Vacuum emulsifying machine operation matters needing attention

vacuum emulsifying machineOperation Precautions:
1. The equipment must be cleaned and disinfected during use. After feeding, the water and oil are heated. The temperature needs to be controlled and set by the thermometer in the electric control cabinet. During the heating process, stirring should be started from time to time to ensure that the material is evenly heated. The mixing time can be adjusted and controlled by the meter on the electric cabinet.
2. When the materials in the oil pan and the water pan are completely mixed and heated to the required temperature, turn on the vacuum comb to make the negative pressure in the main pan 0.06mpa. Suction the material in the oil pot into the main pot in turn (according to the material conditions, first absorb the parts of the oil pot or water pot). Start upmixing at the same time, and the speed can be adjusted to the required speed according to different products.

3. Time and speed can be set according to different products. The time is controlled by instruments in the electrical control cabinet. The time is generally 3-20 minutes (frequency conversion speed regulation, factory setting is 200-3300rpm). During the emulsification process, the emulsification speed and time can be changed according to different formulations. During the emulsification, the emulsified state of the material can be seen from the observation hole. When the emulsification requirements are met, the homogenization system is turned off.
4. When cooling the material, open the cooling water valve for circulating cooling, and the stirring speed will decrease as the temperature decreases. The vacuum degree of the emulsion tank should be kept at about-0.05Mpa. It can also be set according to different material groups. When the temperature drops to 50 degrees, different flavors, preservatives and other auxiliary materials can be added according to different recipes.
5. When the temperature drops to the discharge temperature, close the cooling water valve and open the discharge valve to start the discharge.