Emulsion machine how to ensure normal operation

Emulsion machineHow to ensure proper operation:

First of all, the power supply must be connected, and the ground wire of the emulsifying machine must be connected reliably to ensure the safety of electricity. Otherwise it is prone to disaster.
2. When the power is turned on, we need to jog the homogenizing head of the rotating emulsifier and observe the steering of the homogenizing head. Looking from top to bottom, counterclockwise rotation indicates that the power supply is correct. If it is clockwise rotation, it indicates that the power supply is reversed and the power supply should be reconnected.
3. When vacuuming, be sure to fill the vacuum pump water tank with water to prevent the vacuum pump from idling. When starting the vacuum pump, check whether the vacuum pipes are sealed to prevent air leakage and avoid insufficient vacuum.
4, the homogenization head of the emulsifier in the absence of medium, it is strictly prohibited to idle, in order to prevent heat, burn out the bearing and seal deformation.
5. When the material needs to be heated, first ensure that there is a heating medium in the emulsifier jacket to prevent dry burning and damage to the heating tube.
6. The vacuum pump is strictly prohibited to open when the lid is not sealed. If there is a special need, it should not be started for more than three minutes to prevent damage.
7. Before closing the vacuum pump, close the ball valve in front of the vacuum pump to prevent air exposure. When you need to raise the lid, be sure to open the air filter, so that the pot body into normal pressure, and then lift operation.
8. In the process of operating the emulsifying machine, if there is abnormal noise, the power must be turned off immediately, and the operation can be carried out only after the cause is found out.
9. During the operation of the emulsifying machine, it is strictly forbidden to extend all parts of the body into the pot to prevent accidents.
When cleaning the emulsifying machine, be sure to cut off all power before it can be carried out to avoid accidents.