Introduction of the Kettle Jacket and Structure Type of Emulsion Machine

In the heating of the vacuum emulsifier, we usually use the jacket in the kettle body for water bath, oil bath or steam heating. What is the kettle body sheath of the emulsifying machine and what types are there? Here we will learn about it with Tianfu Xiaobian!

1. what is the emulsifying machine kettle body jacket?

On the side of the tank body of the vacuum emulsifier, various steel structures with different shapes can be installed by welding connection or flange connection to create a sealed area with the outer surface layer of the kettle body of the vacuum emulsifier, and hot fluid can be introduced into this area to heat or cool the materials in the kettle body and maintain the average temperature of the raw materials within the expected range. Such steel structures are also called jackets. Jacket type can be divided into many kinds, and the integrated jacket is a kind of vacuum emulsifying machine commonly used.

The integrated jacket is to set a container with a slightly larger diameter outside the tank of the vacuum homogenizing emulsifying machine. Such jackets are simple and convenient and usually do not need to be repaired. The disadvantage is that the heat transfer area is limited by the geometric shape of the tank of the vacuum homogenizing emulsifier and cannot be made too large.

Type of jacket structure of 2. vacuum emulsifying machine kettle body

The structure of the integrated jacket can be divided into 4 kinds of structures according to the coating degree of the kettle body of the vacuum homogenizing emulsifier:

The specific position of the vacuum homogenizing emulsifier has a jacket, which is used in occasions where the heating area is small. A certain part of the vacuum homogenizing emulsifier and the lower head have a jacket. Such a jacket is a typical structure commonly used in vacuum homogenizing emulsifier.

In order to reduce the external pressure calculation length of the tank of the vacuum homogenization emulsifier (when the tank wall thickness is calculated according to the external) or to adjust the average temperature in sections in the axis direction of the tank of the vacuum homogenization emulsifier for heating and cooling, a reinforcing ring is arranged in the middle of each section or a jacket sealing member that can play the role of the reinforcing ring is selected. This structure should not be used in the tank of the vacuum emulsifier, instead, it is used in the tank more slender occasions.

It is a fully clad jacket, which has the largest heat transfer area compared to the first three jackets. However, the basic vacuum homogenizing emulsifier does not apply such as jacket.